Hietakari Forma 304 kääntyvä suihkuseinä kiinteällä osalla

The shower screen consisting of a fixed part and of a hinged part hinged to it protects the space and the fixture next to the shower from splashing water. The fixed part efficiently restricts water and when the shower is not in use the hinged part can be turned to the side. Due to the combination of the fixed and the hinged part the shower screen can be dimensioned also in a cramped space so that the hinged part does not hit other fixture. The hinged part of the shower screen turns to both directions 90 degrees and is equipped with adjustable centring. The centring attempts to return the hinged part back to the open and closed positions. The profiles mounted to the edges of the panel are manufactured of aluminium. The white (RAL 9016) and black (RAL 9005) surface treatment options are manufactured by powder coating. Grey and bright are anodized coatings. Profiles are sandblasted before anodization, so that the surface is as smooth as possible and there will be no fingerprints. The fittings used in the product, like square foot and brace bars, are made of chrome plated brass alloy. The product is manufactured of 6mm thick tempered safety panel (EN 12150). The safety panel can be treated in the factory with Cranith calcification prevention coating. The coating enables the panel to stay clean easier. Clear, grey and bronze are smooth surfaced and transparent glasses. Chinchilla, satin and reeded glasses are not fully transparent, details cannot be made out through the panel. Chinchilla and reeded are textured on one side and smooth on the other side. One side of the satin panel is etched to acquire a velvety feel and the other side is smooth. When choosing a satin panel product, bear in mind that the etched surface of the panel is sensitive to scratches and stains. Install Shower screen is attached by its sides to the building wall with a wall mountedprofile. The fixed wall is supported from the top edge with the brace installed in the corner and from the bottom corner by the fitting glued to the floor. Between the panel of the fixed part and the floor will be a 25mm high gap. seal (standard part)s may be installed between the panel and the may be installed a seal (standard part) , so that water will not be able to under the panel. In the bottom edge of the hinged part can be installed can be installed along the bottom edge of the door panel.